![]() ![]() ![]() And in terms of RAM, you can run Tiny10 on a 32-bit system with just 1GB of RAM, and on a 64-bit system, you can make do with 2GB of RAM, which is nothing short of amazing. On 64-bit systems, Tiny10 takes up to 10GB of disk space. To reduce the installation size by 17GB is just great. A vanilla Windows 10 system takes up to 22GB of space. if it isn't you obviously cannot configure anything manually.For example, if you install Tiny10 on a 32-bit system, it only takes 5.2GB of disk space, which is a breakthrough. of course you need to verify first that your client Ethernet card is working. Basically, this is a networking problem, not really anything VMware specific - if that helps to analyze the situation. If you need an UNC-share for some application, of course then you need to get the networking to work. Just drag and drop between host and client - it works well with GB-class files - the write speed of the disk(s) is the main limiting factor. When you get it to work, open Firewalls and configure properly.įor filesharing, you don't necessarily need any of this. If it doesn't work, check that Host computer doesn't block anything - disable all Firewalls or something and reboot to verify that they are shut. or the testing has been wrong: Your host access might have been OK, but Internet doesn't work because Gateway address is wrong. It kind of sounds that you don't automatically get correct addresses to your client or shuffling between NAT and Bridged may have caused confusion or proper reboots have not been done between trials. Please observe that also Gateway must be correct if you require Internet access. If your addresses are somehow wrong, change them manually. ![]() Please make a note that while ping might work, tcp/ip doesn't really work for all services if you don't boot the Windows computer (talking about client now). Check your address space with "ipconfig /all" - it has to be the same as NAT networking address space. Not sure what the problem is, but try only NAT, in order to avoid confusion and for Host access this is the simple way. You don't need VMware Tools for this to work. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |